The AMP600 is a robust, high-impedance Class D amplifier, ideal for fixed installations.
– Output power: 600 W
– Compatible with 100 V lines only
– Class D for optimum energy efficiency
– Continuous temperature management and thermo-regulated fan cooling
– Rear volume control
– Auto-standby after 15 minutes without signal
– Input and output connections via Euroblock connectors for fast, secure installation
Features
Power and Impedance:
- Power Output: 600 watts at 100 volts
- Output Impedance: 17 ohms at 100 volts
Audio Performance:
- Input Sensitivity: 0 dBV for 20k ohms balanced inputs
- Frequency Response: 20 Hz to 20 kHz, suitable for full-range audio performance
- Total Harmonic Distortion plus Noise (THD+N): Less than 0.1%, indicating low distortion
- Signal-to-Noise Ratio (S/N): Greater than 100 dB, suggesting a low noise level and high dynamic range
- Damping Factor: Greater than 500 at 1 kHz, correlating to better control over connected loudspeakers
Construction:
- Power Circuit: Class D design, known for high efficiency and low heat output
- Power Supply: PFC switching power supply, which operates within AC 90-264 V, 50/60 Hz range, allowing global operation
Protection and Safety Features:
- Protections against short-circuit, open circuit, thermal overload, limiter, and ultrasonic/RF interference
Connectivity:
- Inputs and Outputs: Uses Euroblock connectors for both input (GND + -) and output (+ -)
Controls and Indicators:
- Settings: Includes an ON/OFF switch on the front panel, volume, and high-pass filter (HPF) located at the rear
- Indicators: Front panel LED indicators for signal presence, -20 dB level, clipping, and protection status
Cooling and Physical Properties:
- Cooling: Thermo-regulated fan, which adjusts speed based on temperature, aiding in heat dissipation
- Dimensions: 483 mm (W) x 88 mm (H) x 425 mm (D), equivalent to a 2U rack mount in a 19-inch rack setup
- Weight: 5.8 kg, making it relatively lightweight for its power output
