The AMP1100 amplifier concentrates 1100 W of 70/100 V line power in a 2U chassis for efficient sound reinforcement in spaces requiring homogeneous audio coverage.
Multi-purpose halls, places of worship, company restaurants: when the installation requires a single source feeding numerous distribution points, a high-power single-channel amplifier becomes the obvious solution. The AMP1100 distributes 1100 W over a 70/100 V line, enabling several loudspeakers to be daisy-chained while preserving signal quality over long distances. Its Class D architecture offers maximum efficiency and thermal stability, while its rear configuration prevents accidental parameter manipulation.
High-performance architecture
This mono amplifier delivers 1100 W at 100 V with full bandwidth from 20 Hz to 20 kHz. Harmonic distortion remains below 0.1% and the signal-to-noise ratio exceeds 100 dB, guaranteeing faithful reproduction and maximum intelligibility. Thermo-regulated fan cooling adapts in real time to thermal constraints, keeping the electronics in their optimum range without generating noise pollution.
Energy-saving Auto Standby
After 15 minutes without signal, the amplifier automatically switches to Auto Standby mode to limit power consumption. Resumption is instantaneous as soon as an audio stream is detected, with no perceptible delay or interruption. This autonomous function significantly reduces the energy bill of intermittent installations, while helping to extend component life.
Simple rack integration
Euroblock terminal blocks provide reliable and fast input and output connections. The volume control and HPF high-pass filter remain confined to the rear panel, preserving the integrity of installer settings. Four front LEDs (Signal, -20 dB, Clip, Protect) keep you constantly informed of operating status. With a weight of 7.8 kg and a standard 2U format, the amplifier fits into any existing technical cabinet.
– Output power: 1100 W
– Compatible with 70/100 V lines
– Class D technology for optimum energy efficiency
– Intelligent thermal management with thermo-regulated ventilation
– Volume control located on the rear of the device
– Auto Standby mode after 15 minutes without signal
– Input and output connections via Euroblock connectors for fast, secure installation
Technical specifications :
– Power at 100 V: 1100 W
– Output impedance at 100V: 17 Ohms
– Input sensitivity: 0 dBV / 20K Ohms balanced
– Frequency response: 20 Hz – 20 kHz
– THD+N : < 0.1%
– S/N : > 100 dB
– Damping factor : > 500 @ 1 kHz
– Power circuit: Class D
– Power supply: PFC switching power supply AC 90-264 V, 50/60 Hz
– Protections: short-circuit, open-circuit, thermal, limiter, ultrasonic and radio frequency
– Connections: input Euroblock GND + – & output Euroblock + -.
– Controls: ON/OFF switch on front panel, volume and HPF on rear panel
– Indicators: Signal, -20 dB, Clip, Protect on front panel
– Cooling: thermo-regulated ventilation
– Dimensions: 483 x 88 x 425 mm (2U, 19-inch)
– Weight: 7.8 kg
